Tag Archives: extruder

Slic3r and Extruder calibration

Rich over at RichRap has just started a series of posts on using Slic3r for preparing STL files for printing, explaining the effects of the various parameters. His first article also includes some good info on calibrating your extruder output, … Continue reading

Posted in 3d printing, Software | Tagged , , , | Leave a comment

Sidestepping my filament feed problem

I still can’t get the bruthead to feed the beginning of a new length of filament directly into the groovemount. It runs fine past the gearhead, and down through the bottom of the printed plastic piece, but it never quite … Continue reading

Posted in 3d printing, Assembly | Tagged , , | 2 Comments