MarkC reminded me I hadn’t written anything about the very first step in getting the ATX supply working. I’ve updated this post yet again, so all the information is in one place.
What is Desktop 3D Printing?
Imagine a robot that sits on your desk, and builds anything you tell it to from a spool of bioplastic.
Imagine that it makes these things by heating up the plastic then squeezing it out like toothpaste from a tube. Imagine it smells faintly of caramelizing sugar.
Imagine that the designs for the printer, the software that runs it, the software that designs things to be printed, and almost infinite quantities of pre-made designs, are all free.
I don't have to imagine any of that, I've got it sitting on my desk right now.
Tags I use
- ancient religions
- cycladic figures
- Doctor Who
- Heated Build Platform
- loom tube
- Mendel Prusa
- molex connector
- Pirate Ship
- screw terminal
- solid geometry
- Stepper motors
Most recent posts
Top Posts & Pages
- ATX power supply 5V load resistor for better 12V regulation
- Teaching Slic3r to remember your settings
- Retraction solution with Marlin, Pronterface and Slic3r
- Cocoon Create Model Maker Adventures
- RAMPS v1.4 connection photographs
- My Slic3r config file
- DIY 3D Printing is easy
- MakerGear Mendel Prusa electronics assembly notes
- Retraction, Huh! What is it good for?